Adobe Audition 2.0 . Как установить на WinXP с проц AMD Athlon?

[Fokus]

Adobe Audition 2.0 . Как установить на WinXP SP2 с проц AMD Athlon?

Сначала при установке отказывается устанавливаться "на эту ОС", при установке в параметрах режима совместимости с WinXP, ей начинает не нравиться процессор - "нет поддержки SSE"

[The Djac]

Может быть ОС - SP1? И вообще, хорошо бы подробнее, скриншоты окон, например...

[toqpuk]

У меня AMD Athlon и проблемы не увидил при установки

[GuitarLover]

Попробуй установить в безопасном режиме!

[N1CKOSS]

У меня Penb 4 HT i865- отлично встал. Если оно тебе такое пишет, то скорее всего у тя сильно древний комп.

[cinder]

Все дело только в инструкциях процессора SSE2

Цитата: SYSTEM REQUIREMENTS Intel® Pentium® III or 4 or Intel Centrino™ (or other SSE-enabled) processor (Pentium 4 or other SSE2-enabled processor required for video)

Статья из базы знаний Adobe (на английском)
http://www.adobe.com/support/techdocs/329332.html

Инструкция по отключению проверки поддержки SSE2

Цитата: Solution 2: Edit the Setup.ini file. You can edit the Setup.ini file for Adobe Production Studio so it will not check for an SSE2 enabled CPU before it attempts to install. Once you have installed Adobe Production Studio using the modified Setup.ini, you can successfully run After Effects 7.0, Audition 2.0, Illustrator CS2, and Photoshop CS2. Note: If you edit the Setup.ini file in order to install Adobe Production Studio, you will not be able to run Premiere Pro 2.0 or Encore DVD 2.0 unless you upgrade your processor to one that supports the SSE2 instruction set. To edit the Setup.ini file: 1. Copy the contents of all of the Adobe Production Studio DVDs to a folder on your hard drive. For instructions on copying the content of these DVDs to your hard drive, see document 328850 , "Troubleshoot installation problems (Adobe Production Studio on Windows)." 2. In Notepad, open the Setup.ini file that you copied in Step 1. This file is located in the Adobe Production Studio folder you created in Step 1. 3. Remove the section of the file requiring SSE2 by deleting the following four lines: Requirement6Type=CPURequirement Requirement6MsgFailure="$$$/ACS/ReqCheckFailureCPUReqSSE2=The Adobe Production Studio needs a processor that supports the SSE2 instruction\nset in order to run properly. Please upgrade your processor or install on a different computer.\n\nThe minimum system requirements for the Adobe Production Studio are:\n\t- Windows XP Service Pack 2\n\t- Intel Pentium 4 processor or better\n\t- 4 GB of hard disk space\n\t- 512 MB of RAM\n\t- CPU supporting the SSE/SSE2 instruction set" Requirement6MsgSuccess= Requirement6Value1=SSE2 4. Save and close the file. 5. Run the Adobe Production Studio Setup.exe file from the folder you created in Step 1.